GenRight Jeep Wrangler JL & JLU Aluminum Alloy Swing Out Rear Tire Carrier

$1,499.99
FREE Shipping!
In stock
SKU
GR-RTC-10010

The New JL GenRight Aluminum Rear Carrier

  • Can Run a 35" up to 42" Tire
  • Rattle Free with 4 Mounting Points
  • Carrier Weighs Only 21 Pounds
  • Fits Any Wheel Pattern
  • License Mounts To Center of Carrier

Fits 2018+ JL & JLU

GenRight Jeep Wrangler JL & JLU Aluminum Alloy Swing Out Rear Tire Carrier
GenRight Jeep Wrangler JL & JLU Aluminum Alloy Swing Out Rear Tire Carrier

The New Rear Tire Carrier from GenRight for the Jeep JL is constructed of 100% Tig Welded Aluminum and is only 21 Pounds. This Carrier is completely independent of the rear bumper and fits nice and snug with 4 mounting points to the factory door hinges.


    Features

    • 1-3/4" diameter x .188" thick wall 6061-T6 Aluminum Alloy tubing
    • 4-point polyurethane mounting is rattle-free and will not open by itself
    • Completely independent from the rear bumper, allowing you to run just about any rear bumper you choose
    • Swing out tube style carrier cage design opens effortlessly
    • Mounts to factory rear door hinges (strong & rattle-free)
    • 100% TIG welded Aluminum
    • Designed to hold from a 35" up to a 42" tires
    • Fits any bolt pattern or wheel offset (stock wheels can be used by running backwards in the carrier)
    • Corrosion-resistant materials require no paint (but can be painted or powder coated if you choose)
    • Fits tighter to the rear tailgate than any other brand rear tire carrier
    • Improves vehicles rear departure angle
    • License plate is re-located to center mount on tire carrier
    • Pre-drilled for license plate and 3rd brake light wiring
    • Can be painted, powder coated, or left raw
    • Includes Stop / Lock
    • Made in the USA

    Notes

    • Requires drilling of four 3/8" holes on drivers side rear area by the tail light to mount the two latch plates
    • Requires that the factory rear door hinges be removed so new GenRight rear door hinges can be installed (no new holes required)
    • Each tire carrier is drilled with a fish wire to allow you to pull electrical power wires through the tubes of the tire carrier
    • This carrier relocates the licence plate from the side to the rear. It is necessary to have a license plate light
    • You can lock this Tire Carrier by replacing one or both of the supplied closure pins with a lockable 1/2" hitch pin

    GenRight Part #-RTC-10010

help desk software
© 2019 RubiTrux.com - Magento Optimization by EKG Marketing.